Electrical Detail Design Engineering Consultant

Category: Substation Layouts

About This Service

23.10 YEARS IN ELECTRICAL DETAIL DESIGN ENGINEERING PROFESSIONAL : POWER PLANTS, REFINERY, OIL & GAS, DISTILLERY, CHEMICAL, WATER TREATMENT & WASTE WATER TREATMENT PLANTS (WTP/STP/ETP) AND COMM. BUILDINGS & HOSPITALS :
 10 (6 + 4) years in Power Plants, Transmission and Distribution.
 10.10 years in Refinery, Oil & Gas, Distillery, Chemical, WTP/STP/ETP Plants.
 7 years in Erection, Commissioning & Maintenance.

Packages

Electrical Details Design Engineering

 TECHNICAL STRENGTH :
 Well versed with Conceptualization, FEED and DE cycles.
 Expertise in Switchyard & Transmission line specifications for 110kV.
 Expertise in Distribution System up to 42 sub stations of 2.5 MVA with Ring Main Units.
 Knowledge of System Study : Short Circuit Study, Load Flow, Transient Analysis, Earthing etc. with ETAP Software and Manual calculations.
 Expertise : Preparation of Drawings, Document & Deliverables list, equipment list, HAZOP study, Hazardous Area Classification, Various Layouts, Cable schedules, Equipment Selection and Specification.
 Detail Electrical Engineering :
Document Preparation : DBR/DPR, Single Line Diagrams, Sizing of equipment, Generation system, Distribution system, Protection system, Selection of HV/MV/LV Switchgear, Various Lists & Schedules, Relay setting, Co-ordination, Electrical Installation Specification etc.
Design Calculations : Short circuit, Load flow, DG sizing, Cable sizing, Earthing, Cable Tray, Battery, Battery Charger, UPS, Indoor/Outdoor Lighting, Lightning etc.
Layouts : Switchgear & Control room, Battery, Battery Charger, UPS, Cable tray indoor & outdoor, Earthing, Hazardous Area, Lighting, Lightning etc.
 Proficient : Tender Specifications, Technical Bid / Offer Evaluations, Vendor Drawing Review, Approval and Co-ordination with site.
 Competent : Electrical Proposals, Scheme Preparation, Man-hrs Calculation, Cost estimates, Understanding of Planning, Scheduling, Time-bound implementation, Management review reports, Standardization, Strong analytical mind set & Conceptual abilities etc.
 Software’s : ETAP, CGlux, Photolux, Dilux, Autocad, Microstation, SP3D, PDS, PDMS.
 Knowledge of 5S, Kaizan, SQP, ISO9001:2008, TQM procedures.
 Managed team of 11 Engineers & 14 Designers.